Contact Info
  • Scan to log on web by Phone/Pad
     

  • Web: www.laitalight.com

    Lightup Lighting Technology Co,Limited

    Address: NO.586 Bingjiang dong Road, Haizhu district, Guangzhou, China, Post: 510000

  • Tel/Fax: 86-760-87562329

  • Email: inquiry@upleds.com

  • MSN Skype talk YL QQ

 

Home > Articles > English > LED knowledge > LED Wall Washer Series Installation Instructions

LED knowledge

LED Wall Washer Series Installation Instructions
From: The Site Author: LGHTUP LED DateTime: 2013-10-12

 

LED Wall Washer Series Installation Instructions


 
After receiving LED wall washer products, please ensure that the product intact. When installed according to the following points to implement in order to avoid installation errors cause the LED wall washer damage.

 

Precautions before installation instructions :

 

  1. Non-professional and technical personnel, please do not attempt to repair or modify the product .
     
  2. In the installation and avoid shock during transport .
     
  3. Turn off the power before installation to avoid improper operation of electric shock.
     
  4. Before installation please note that check mark on the wall washer is about connecting the voltage of the input voltage is the same, so as not to damage the LED wall washer .
     
  5. After selecting the installation location , the lighting on the mounting position can be fixed with screws , connecting thread , please do a good job in the joints waterproofing treatment .
     
  6. In order to ensure the longlife of the product , please do not place the use of concentrated acid mist .
     
  7. Make sure the installment place could afford 10 times the weight of the product , installed in no vibration no swing, no fire hazards flat place ;
     
  8. The Control system through the early design engineers and design, when used under normal operating conditions, the use of color-changingeffects after work, you can achieve the most optimized LED life. Outside these ranges or conditions and limitations of these long-term work, will further reduce the lifetime of the LED, in extreme cases, the internal light source assembly failures.
     
  9. When the installation of lighting gently to avoid damage to the lamps.
     
  10. Found lamp cord is damaged, stop using it immediately power off .

 


Installation Instructions:

 

  1. First, screw the lamp firmly fixed ;
     
  2. The lamp and the power cord is firmly connected , no lint wrapped with waterproof adhesive tape ;
     
  3. When installing wiring up a branch of the power station wall washer series 8-10pcs ; or after 50 meters then use new the power cord.
     
  4. After installation is complete , please check the installation line to confirm correct installation , no electrical short circuit , connected to the corresponding control power ;
     
  5. If a problem occurs during installation , please consult our technical staff ;

 

 

 

External control DMX512 LED Wall Washer Installation diagram:

 

 

External control DMX512 LED Wall Washer Installation diagram LIGHTUP LED
 

 

Note: The figure wall washer working voltage is AC220V example . If the LED wall washer voltage is AC24V, the access voltage must be AC24V

 

 

 

 

Monochrome / internal LED wall washer installation diagram :

 

Monochrome / internal LED wall washer installation diagram-LIGHTUP LED

 

 

 

 

Note: The figure wall washer working voltage is AC220V example . If the LED wall washer voltage is AC24V, the access voltage must be AC24V

 

 

 

 


Related Articles